spderbox 150 taking off problems

Status
Not open for further replies.

jtrc123

New member
Messages
5
Reaction score
0
Location
maryland
We have a spiderbox 150. It broke the drive belt. We got a new belt double checked ro make sure it was the right one. We put it on and now it has no power to take off. We changed the driven clutch thinking maybe that is what caused the problem. No luck it starts and idles ok but as when u give it gas it wont take off. The engine shakes something terrible. If u push it and get it going it smoothes out any help is appreciated. My kids r driving me crazy wanting to ride>:confused:
 

jtrc123

New member
Messages
5
Reaction score
0
Location
maryland
yes it did but we made sure we had the right belt. My dad thinks it went out of time when the belt broke. thank you for taking time to help
 

exenos

Project Nut
Messages
1,217
Reaction score
0
Location
Ontario, Canada
Went out of time? what do you mean by that?

It sounds like the primary clutch ( engine clutch) is not contracting. A good cleaning should fix that.
 

jtrc123

New member
Messages
5
Reaction score
0
Location
maryland
Is that the same as the variator clutch? The small one on the front. My father said the clip behind the flywheel probably broke or twisted when the belt broke (which messed up the timing) but we gave not taken the flywheel off we dont have a puller.
 

OzFab

Well-known member
Messages
15,615
Reaction score
76
Location
Warwick Qld, Australia
You shouldn't need a puller to remove the flywheel: just remove the retaining nut, give the end of the shaft a light tap or two (not directly though, put a small piece of metal between the hammer & the shaft to avoid damage) & it should come loose.

However, you shouldn't need to do that. If your timing was gonna go it would more likely shear the key & your engine wouldn't start at all. Still, you can check it just to be sure. If nothing else, it's good practice
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Just a couple more suggestions toward getting the flywheel off- Do NOT smack the crankshaft directly with a hammer (like Fab said), but instead try this- Loosen the retaining nut by a turn or two, but do not remove it. Make sure the nut sticks out more than the end of the shaft, but still engages several threads. Now- smack the nut with a couple of sharp blows. It should release. It may help to tap around the perimeter of the flywheel with your hammer, but do not strike the cooling fins, and do not try to hit a home run.
 

jtrc123

New member
Messages
5
Reaction score
0
Location
maryland
Took the clutch off and the bushings were all over the place put it back together ran great for 5 min then back to the same thig gonna take it back apart tommorow. U guus r great thanks for the help
 
Status
Not open for further replies.
Top