spark plug gap setting....?

Status
Not open for further replies.

supermanotorious

Winchmaster 5000
Messages
2,088
Reaction score
103
Location
New River, AZ
as crazy as this sounds I only recently learned about the plug gap and its importance to an engine, so I'm wondering if maybe thats why my Tecumseh wont idle properly, does anyone know what proper spacing on that engine is? .050?
 

Russ2251

AZUSA:Powered by LAWN-BOY
Messages
6,622
Reaction score
47
Location
Huntington Station, Long Island, NY
Depends on engine. What engine do you have? Usually .020 to .030".
Get the manual and refer to it. Guess work rarely gets the job done. There are specs for good reason.
Please educate yourself!!!

How's that for blunt.
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
While not necessarily the "ideal" gap for a particular engine, I find 0.030" to be a good gap for "unknowns" until I can find the proper spec. 0.050" is far too large.
 

supermanotorious

Winchmaster 5000
Messages
2,088
Reaction score
103
Location
New River, AZ
here it is as derived from Service Information:

5. When replacing the spark plug, consult the parts breakdown for the proper spark plug to be used in the engine being serviced. Set the spark plug gap to .030" (.762 mm) and install the spark plug in the engine. Tighten the spark plug to 15 foot pounds of torque (20.4 Nm). If a torque wrench isn’t available, screw the spark plug in as far as possible by hand, and use a spark plug wrench to turn the spark plug 1/8 to 1/4 turn further if using the old spark plug, or 1/2 turn further if using a new spark plug.

My engine is OHH65, Service Number 34645, Champion plug RN-4C or Autolite 403
 

supermanotorious

Winchmaster 5000
Messages
2,088
Reaction score
103
Location
New River, AZ
well I adjusted the gap setting but still no luck with idle, I'm back to thinking its either the felt washer on top of the butterfly valve or a problem with the idle circuit, I've heavily coated the felt washer with grease and cleaned the idle jet, at this point I may have to take the whole carb apart again and flush the idle orifices
 
Status
Not open for further replies.
Top