solved the hard to pull start problem

Status
Not open for further replies.

Davidgx200

New member
Messages
54
Reaction score
0
Location
Aiken South Carolina
hard to pull start problem solved

This may be helpful to someone in the future because when I had the problem with the recoil trying to rip my arm off, I was told the compression itself was the cause then all I kept reading was valve lash. I was searching for troubleshooting and repairing compression release on clone cam. I never found anything I took the cam out and the compression release was even with the exhaust lobe so I took a flathead and pried it up some swung the arm over and pulled up with some pliers until the arm stuck up above the lobe, reinstalled the cam and it pulled easy as it did stock even with the increased compression. I hope this helps people out in the future. The one thing I did find online with my searches was this is a common problem with not to many solutions besides cam and ignition timing, sheared key and valve lash which was the most given advise. I read some people purchased a new cam then it worked so they recommended that also.
 
Last edited:

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Okay- so it did boil down to the compression relief mechanism disagreeing with valvetrain changes?

Glad you got it sorted out. Engine running yet?
 

Davidgx200

New member
Messages
54
Reaction score
0
Location
Aiken South Carolina
not yet just got my 18cc head in today thought maybe too much compression with all that was happening also got new head gasket. turned out the head was milled 0.065" or what im told its flush with the fin and 0.020 longer arc billet rod. But may go back with it but its blown 2 head gasket i feel a spot that doesnt feel even on the edge where the oil showed up.
 
Status
Not open for further replies.
Top