Simple GX200 + Clone Mods

[The Product]

hey guys,

never found a thread for this

just list ur simple mods and/or simple tricks to boost performance on the GX200 motor

i got:
governor removed
6* timing advance
18 lbs. valve springs
header
soon to be billet rod

 

[freakboy]

Port polish, decked heads, govenor removal, carb mods... thats all i do to any engine i get... its much cheeper to buy a bigger engine then to throw lots of mods in a engine specialy for a non racing kart...

 

[lemegacool]

18 lbs valve spring, 1:3 rockers...



and of course (haha not simple but i heard "boost" soooo

 

[The Product]

what is that?

 

[1992suburban]

air filter adapter and a header and a rejet of the carb.. BASICS right after gov. removal

 

[mike75925]

add a lash cap to the intake; lob off the stock muffler and use a piece of bicycle handle bar for an extension. remove the paper from the stock element (breather); remove every other fin on the cooling fan, and maybe cut each remaining fin down by half. i wish i knew where to get thicker lash caps! head gasket swap if you have the thick one. plugging off the emissions tube on the breather casing. when you remove the stock filter from the breather assm. you can cut the girdles on an angle (one each way) to spin your fuel air mix up. carb gasket alignment;

 

[lemegacool]

what is that?

turbocharger

 

[The Product]

thats sick lmao