shaky

Status
Not open for further replies.

kendelrk

redneck engineer
Messages
2,425
Reaction score
9
Location
westland michigan
well finally getting everything right with my mini bike today, including having to cut keyway, repair a chain and get a new master link i finally got to ride it, it was really wobbly when i rode the gas tank, so i tightened that down and everything was ok, so i rode it down to the gas station and got gas but i noticed that when i start to push in the throttle the engine shakes before fully engaging, why?
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Look at it closely when it does it. Small, single cylinder industrial engines have a tendency to vibrate by nature, often just in a certain RPM/load range. In addition, your mounts may not be torqued down enough. It's also possible that the mount itself is flexing and could do with some structural support. Considering the damage repair you just did, I'd say there's a good chance this is your problem.
 

kendelrk

redneck engineer
Messages
2,425
Reaction score
9
Location
westland michigan
i tightened them as much as i could then had my uncle turn the as tightly as he could, so i do believe its tourqed down enough. and it does sound like its flexing itself, because when i pull the throttle lever back, it starts really shaky, but once it gets moving it smooths out, so how could i give it a better structure?
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
my scrap bike made grinding noises then smoothed out as i sped up.

chain was too loose and it was slipping around the clutch.
 
Status
Not open for further replies.
Top