Sachs ST 96

Status
Not open for further replies.

denhammotors

Member
Messages
117
Reaction score
0
Location
Stuart, Florida
I bought this engine a couple days ago. It's a new old stock Sachs Stamo 96 (93cc) two stroke. I have already run it and will post a video soon. It has a 15mm shaft, so it might be difficult to find a clutch that will work for it. It's rated 3.7 HP at 5000 rpm. I was wondering if anyone else here has one of these engines or knows anything about them. This is the only info I could find- http://www.sachs-stationaermotoren.de/st96.html
 

Attachments

  • DSCF1060.jpg
    DSCF1060.jpg
    70.6 KB · Views: 16
  • DSCF1062.jpg
    DSCF1062.jpg
    61.8 KB · Views: 17
  • DSCF1063.jpg
    DSCF1063.jpg
    67.7 KB · Views: 16

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
What a perfectly cool little engine! You could maybe use a strip of shim stock to fit a 5/8" clutch, or maybe have a bushing made to fit a larger clutch.
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Ahh... There's more than one way to skin a cat. Some clutches come equipped with setscrews. A dab of blue Loctite #242 and you're off to the races. I've even heard of folks leaving the clutch "floating" on the shaft!
 

scarletvw

New member
Messages
94
Reaction score
2
Location
Minnesota
The previous owner of my cart used washers to make up for slop and the clutch is essentially floating with no set screw and just the boot at the end.
 

OzFab

Well-known member
Messages
15,615
Reaction score
76
Location
Warwick Qld, Australia
Wouldn't the small amount of axial movement slowly wear out the shaft?

How's that work with lateral g forces??? By all means it should slide off without a chain guide?

I don't understand what all the confusion is about, it's quite simple:
if you fit a cc & leave the set screws out it will move back & forth on the shaft. As long as the washer on the end of the shaft is big enough, the clutch has nowhere to go.

As for wear on the shaft & lateral g force, it still has a key holding it in place & will still turn with the engine so the same forces will be exerted on the clutch so very little, if any wear will occur. With the driven sprocket fixed, the amount of lateral movement will be negligable.

The main reasons I can see for using this method is to reduce/eliminate side load on the chain, derailing chains & more exact chain alignments. As you all know, the faster you go, the more alignment matters...
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
I don't understand what all the confusion is about, it's quite simple:
if you fit a cc & leave the set screws out it will move back & forth on the shaft. As long as the washer on the end of the shaft is big enough, the clutch has nowhere to go.

This:
Yeah, I was thinking of shimming it like that, but the clutch might be too wide for a nut to fit on the end.

Bit of confusion here, we were discussing the possibility that the OP may bot be able to fit any kind of retainer. The shaft has an externally threaded end and may be too short.
 
Status
Not open for further replies.
Top