Reverse Trike - Mini T-Rex

[mechanicalkid]

Hi,

After doing a Go-Kart and a Mini-Bike, I decided I needed a new project. I read a lot of threads on the forum and some chapters of Carroll Smith's books about suspension dynamics. I drew up the plan on ViaCad 2d/3d.

Two months ago, I did a first version. It was too heavy and not enought strong. I recently did a new version; my design is getting pretty good. The weight of the frame is about 85lbs. I'm also planning to buy a Yamaha Warrior 350cc engine. It has 6 gears with a manual clutch. I will buy trailer wheels at Princess Auto. 16.5 x 6.5 - 8

Please take a look and give me your thoughts, comments and/or suggestions!!! I would really appreciate it.

 

[Ferrari motors15]

Good job what is the mesures of this beast

 

[mechanicalkid]

It's approximately 6-1/2' long and 2' large. I will use steel tube. Outer diameter: one inch.
Wall: .120

 

[joshpit2003]

any chance you could throw some "perspective" into the model? usually there is a button or checkbox for using perspective. because right now I think it looks a little strange and that may just be the lack of perspective.