replace gx200 clone spark plug wire

Status
Not open for further replies.

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
Ok, we all know that the rubber on these chinese parts is of a very high quality...
My clone has a good coil, however the plug wire sheathing split completely and I need to replace the wire. I found this and wondered if there is an easy way to install it onto the old coil? If not, it will be some lighting cable, solder and heatshrink time :)
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
7mm sounds right. there is a wood screw in both the boot and the coil that the wire twists onto.
 

Blazkowiez

Kart Aficionado
Messages
2,538
Reaction score
48
Location
Houston, Texas
NGK makes a very good replacement boot that any local lawnmower shop can order out of their supply catalogues. Should be about 5 dollars. Is that your main problem or is it not the top at the sheathing on the wire solely?

If the wire is not damaged, I've seen people use silicone wrap, and heat shrinking.
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
The boot had a small crack but I glued it up. It works ok.
The wire is ok, but could do with replacing.
Thanks blue, I didn't realise it had a screw into the coil. It should be easy then. I will take a look :)
 
Status
Not open for further replies.
Top