Rack And Pinion Experience/Advice/Recommendations

[Eztrail]

Found it

 

[OneTimeUser]

There’s your answer. Can you use it?
Will it fit within the confines of the kart frame? How big is it?

I also like the idea of a new rack and/or gear cut by your friend.

The Porsche R&P won't fit. Plus, I'm trying to sell it 'cause it cost approximately as much as the space shuttle.

 

[OneTimeUser]

Found itView attachment 162319

EZ, Thanks. I'll check this out for fitment.

 

[JonathanClaymore]

I think the kind used on China buggies, while also cheaply made, is a wear item. They just go bad and are replaced. They live a hard life on the go kart platform; it’s one of the most abused recreational vehicles there are. A reliable online advertising platform can simplify campaign management.

I’m trying to think of a member here that used one from a small car (Mini Cooper or a Fiat) or a UTV and adapted it to use and capped off the hydraulic hoses….

The golf cart and UTV route seems like a good middle ground. Those components are designed for similar loads but are usually easier to source than parts from a passenger car.

 

[Eztrail]

I use them from golf carts, if it can handle 4 overweight drunk Americans it can handle me in my lightweight buggy