Hi,
I'm new to the forum.
I got a pretty strange project on my hand.
It's not exactly a go kart. But the idea behind using a pulse fuel pump (which is pretty popular I think) is essentially the same.
I have an engine with the misfortune of having the fuel tank on a lower level than the carburetor.
I fitted the fuel pump in the attachments (it's meant for a 150cc scooter), that's the only pulse pump I can get.
1/ The inlet line into the pump is fitted with a standard fuel filter (not screen).
2/ The outlet line into the carburetor is also fitted with the same type of fuel filter.
3/ The pulse line is connected to a fitting I drilled and installed on the intake manifold, image is in the attachments.
Question:
1/ If I understand correctly, the pulse fuel pump, if connected to the intake manifold, would work based on the rpm of the engine?
2/ With my setup, will my intake valve's health affect how the fuel pump works as well? Since the vacuum is created through the intake valve after all?
3/ Now the strange part, I tested my pump today. At idle (about 1600rpm), the pump works fine. But when I increase the rpm with the throttle, the fuel flow stops.
I did hold the fuel line a bit too high but is this a sign of trouble?
To make sure, I connected everything again, then I take the engine out on a run at a constant 80kph (about 50mph) for 30s. I figure if the pump does not work properly, my engine would run out of fuel very fast at that speed but everything seems to be fine. Any explanation?
I'm new to the forum.
I got a pretty strange project on my hand.
It's not exactly a go kart. But the idea behind using a pulse fuel pump (which is pretty popular I think) is essentially the same.
I have an engine with the misfortune of having the fuel tank on a lower level than the carburetor.
I fitted the fuel pump in the attachments (it's meant for a 150cc scooter), that's the only pulse pump I can get.
1/ The inlet line into the pump is fitted with a standard fuel filter (not screen).
2/ The outlet line into the carburetor is also fitted with the same type of fuel filter.
3/ The pulse line is connected to a fitting I drilled and installed on the intake manifold, image is in the attachments.
Question:
1/ If I understand correctly, the pulse fuel pump, if connected to the intake manifold, would work based on the rpm of the engine?
2/ With my setup, will my intake valve's health affect how the fuel pump works as well? Since the vacuum is created through the intake valve after all?
3/ Now the strange part, I tested my pump today. At idle (about 1600rpm), the pump works fine. But when I increase the rpm with the throttle, the fuel flow stops.
I did hold the fuel line a bit too high but is this a sign of trouble?
To make sure, I connected everything again, then I take the engine out on a run at a constant 80kph (about 50mph) for 30s. I figure if the pump does not work properly, my engine would run out of fuel very fast at that speed but everything seems to be fine. Any explanation?
