Question about Horsepower

Status
Not open for further replies.

Brandon1023

needs an oil change
Messages
422
Reaction score
4
Location
Miami, Florida, Dade County 305
Okay so since January of 2005, I've had a simple Carter go kart with a 6.5 HP engine. All is well but being the fact that I got it for my 10th birthday and that I'm almost 17 now, I'm out growing it. My dad has a never used B&S generator in the garage and the engine is 10 HP. I doubt he'd let me use it for my go kart but hey I'm just trying to fulfill my curiosity. If I stuck that thing on my go kart, what would the difference be? Would I go a lot faster due to the horsepower? I thought RPM is what makes the speed go on the go kart. There's a sticker on the generator which says "Single Phase / 3600 RPM".

One more question. In the generator, what pulls the throttle open? Obvious in a go kart, the person steps on the gas which pulls the governor . What's the case with the generator? Thanks.
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
First- The generator's PTO shaft is tapered, and therefore unuseable. You would need a trip to a machine shop or a new crank.

Second, RPM DOES equal speed, but not as simply as you might think. While a 10hp engine turns the same governed RPM as the 6hp, the 10hp can be geared higher, and will have more power to pull through the low end to a higher top speed.
 

Brandon1023

needs an oil change
Messages
422
Reaction score
4
Location
Miami, Florida, Dade County 305
Ok. So if I took the alternator off the generator engine, there's no way you could throw a clutch on there? And also, with the generator's current set up, (alternator and everything) what controls the throttle like I asked above? Does it somehow sense the amount of power being drawn and adjusts the throttle accordingly?
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Again- you're looking at an expensive trip to a machine shop to have your crank machined, or you have to buy a new crank.

Some generators have an automatic idle control, some have to be throttled manually, some run full-bore (3600) full-time. What you have to do depends on which system it uses. Your biggest problem is the crank.
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
^^pretty much what toystory said, the 6hp and 10hp will go the same speed with the same gearing because they both turn 3600RPM. however, the 10hp will be able to accelerate you to the same speed the 6hp can but faster. you will have more torque, more take off, more hill climbing power.

because the 10hp is more powerful you can put a steeper gear ratio on it and get away with a higher top speed.

but first, generators have a tapered crankshaft, so you cant put a clutch on it.


EDIT: most generators that have no throttle control are made to run at 3600RPM. when you put load on it, the engine slows down. the mechanical governor in the engine gets looser and allows the throttle to open up more to compensate the load and bring it back up to 3600RPM.

you can buy a regular 10hp throttle setup, or remove the governor and connect the throttle cable right to the carb. the engine will now be able to turn about 4500RPM but doing this can blow it up over time.
 

Brandon1023

needs an oil change
Messages
422
Reaction score
4
Location
Miami, Florida, Dade County 305
Ok thanks. It was just an idea but you answered it. So let's assume I did want to put the engine on the go kart. How would the throttle cable be connected to the engine? On my 6.5, theres a small bracket that keeps the cable in place and the cable is screwed in to the governor arm.
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
It would depend on which of the above throttle control systems the genny used. Ultimately, it all boils down to the same type of mechanical connection that you're used to seeing.
 

Brandon1023

needs an oil change
Messages
422
Reaction score
4
Location
Miami, Florida, Dade County 305
Alrighttt. That's all cleared up. Could you answer one more thing, which is probably a self explanatory question? I know how torque is twisting power. So can you explain what exactly horsepower consists of? From what you said, both engines operate at the same governed speed more or less. So what makes the generator have more horsepower than the go kart engine? Bigger piston? what?
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Basically? Displacement. Bigger cylinder, bigger piston, more air/fuel mix being burnt per cycle.

Think about comparing 6 lbs of dynamite to 10lbs. Bigger bang...
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Hey- Ask all you want- that's why this forum exists! To be truthful, you could probably answer a lot of your own questions just making use of the search feature here, and browsing old posts. That said, no problem!
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
i got nothin to do tonight man id be willing to answer questions haha.

about the shaft, yours will look like this:


you need it to look like this:
 
Status
Not open for further replies.
Top