So I bought this part from gopowersports, Brake kit, and installed it on my kart. However, due to placement of the master cylinder, I needed longer front lines and shorter rear line, so I replaced them all and bled the system.
It is a dual plunger system. The front worked perfectly fine but the rear had no fluid pressure at all, and after disconnecting the line from the master cylinder and pumping the brakes there was no fluid coming out. So I bought a replacement master cylinder and installed it and now the rear works perfect but the front will not....
The front brakes bleed just fine, I am not getting any bubbles and plenty of fluid getting pushed through the system, enough pressure to push fluid into my catch can when bleeding, but the front calipers are not engaging at all... And nothing has changed, they worked perfectly fine before replacing the master cylinder.
Any ideas?
It is a dual plunger system. The front worked perfectly fine but the rear had no fluid pressure at all, and after disconnecting the line from the master cylinder and pumping the brakes there was no fluid coming out. So I bought a replacement master cylinder and installed it and now the rear works perfect but the front will not....
The front brakes bleed just fine, I am not getting any bubbles and plenty of fluid getting pushed through the system, enough pressure to push fluid into my catch can when bleeding, but the front calipers are not engaging at all... And nothing has changed, they worked perfectly fine before replacing the master cylinder.
Any ideas?