proper mini bike drivetrain?

Status
Not open for further replies.

kva

New member
Messages
1
Reaction score
0
Considering building a simple mini bike for the kids.
Have a B&S 60102 horizontal 5/8" shaft.
I guess approx 2hp.
Considering simple cheap centrifugal clutch (for example max torque) and 11 to 72 ratio direct drive to wheel by 35# chain.
Assuming approx 3000rpm on engine, and with ø26cm wheel (=10,2")
the speed is 22,4km/h (=14miles/h)

Does this setup sound ok? Will the clutch handle this, and do the work?
Is the clutch slipping during acceleration, or will it be a rough push in the bike when the clutch couples in?

Does the 22km/h sounds like a fine speed for 9 year kid, driving around the yard?

Any idea what is safe max rpm on a Briggs 60102 (not overspeeding to breakdown) ?
 

OzFab

Well-known member
Messages
15,615
Reaction score
76
Location
Warwick Qld, Australia
:welcome2:

Assuming approx 3000rpm on engine

Assume 3600rpm, that's the typical governed speed of industrial engines...

Does this setup sound ok? Will the clutch handle this, and do the work?

Sounds prefect...

Is the clutch slipping during acceleration, or will it be a rough push in the bike when the clutch couples in?

Technically, yes, the clutch slips until around 2200rpm, at which point, it locks smoothly...

Does the 22km/h sounds like a fine speed for 9 year kid, driving around the yard?

Realistically, that depends on the kid but, it sounds ok to me...

Any idea what is safe max rpm on a Briggs 60102 (not overspeeding to breakdown) ?

With the governor removed, the engine will max out at around 5000rpm when valve bounce/float occurs; as long as it's not run at that speed for too long, it should be fine...
 
Status
Not open for further replies.
Top