Preditor 212 keeps stalling

Status
Not open for further replies.

helix

New member
Messages
2
Reaction score
0
New guy here with a weird issue. I just installed a preditor 212 engine on my sons' go kart from a briggs 5hp. The briggs was hard to start and was really wore out. My issue is when I drive the kart its fine, it never dies. When my son drive who is only about 55lbs, he'll go in a turn, let off the gas then when through the turn he hits the gas and it dies. It never does it with me and if i stand on the back of it while he drives, its never stalls. I do have the engine limited back but like I said it dosent do it with me. Is it a weight and load issue? is there a fix in the carb for this? I've considered putting 100 lb sand bag on the back. All I can think that its flooding itself through the turns and when he hits the gas, it chokes out.
 

devino246

Official DIYGK Chem Nerd
Messages
3,856
Reaction score
17
Location
Lynchburg, VA
Have you disconnected the low oil sensor?

 

helix

New member
Messages
2
Reaction score
0
I considered that and I'll try it. I dont think its a issue, my turns are tighter than his on purpose to figure out whats going on.
 

Gokartguy04

Pickin junk is my thing
Messages
29
Reaction score
0
Location
Colorado
I had this same issue on mine and I just disconnected the low oil sensor and I haven't had a issue sense
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
I agree with devino246, it def sounds like the oil sensor is still hooked up. Thats a NO NO on go karts! LOL!

Generally. I ran the absolute pee out of my GX340 off-road with the low oil sensor circuit intact. To give you an idea, I was thrashing about so hard that I had to install a 4-point harness to keep from getting tossed out. The kart had no suspension, and after maybe an hour, my entire body ached from the beating. In four years of doing so, I think the system tripped 3 times. Maybe there was some luck involved, maybe it's because I'm anal about oil changes and level checks. Maybe both. Either way, disconnecting the sensor is very commonly done to troubleshoot stalling problems and does turn out to be the culprit more often than not. It should go without saying that once you are sensor-less, check your oil level religiously. Your engine's life depends on it.
 
Status
Not open for further replies.
Top