predator problem?

Status
Not open for further replies.

kendelrk

redneck engineer
Messages
2,425
Reaction score
9
Location
westland michigan
alright so my moms friend gave me back my tav2 and just payed the money to get me a new in box motor. so i got it out and installed it. i noticed after running it for a little bit that when i let it idle it seems to have an uneven idle. is this normal? if not ill be off to get another
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
My clone has an even idle. You could spend 10 minutes checking the carb over for any obvious obstructions, e.g. Gaskets the wrong way or bits of casting obstructing flow.
 

kendelrk

redneck engineer
Messages
2,425
Reaction score
9
Location
westland michigan
so im bringing back this thread as ive had the engine off, it hasn't been run in a while so i figured id let it run for a little bit. i notice that it runs un even and terrible after start up, and after it gots hot (5-10 minutes) it seems to idle steady and fine but otherwise its surging and shaking, i put on my aftermarket filter and it idled much better but was way to lean, but also it dosent want to be on choke long and this is a predator so no adjustable carb. and at the same time after i let off the throttle it takes around 3-5 seconds for it to decelerate fully. heres a video of what its doing and sorry for the weird zooming and such. i checked all gaskets and all are perfectly installed. http://www.youtube.com/watch?v=PhixK488SkY
 
Status
Not open for further replies.
Top