Predator 420cc

Status
Not open for further replies.

ross15

New member
Messages
5
Reaction score
0
i just bought a go kart with a Predator 420cc engine off of craigslist and i need to replace the clutch they said it broke because it wasn't strong enough to support the engine. what type of clutch do I need?
 

KartFab

Active member
Messages
3,381
Reaction score
60
Location
Dallas, TX
you have a yerf dog go kart there (possibly 3203, repainted)

This is a crossroads for you. You have a few options

1) keep engine, put on torque converter=most fun!
You can get a bolt on 40 series torque converter here, or you can try and fabricate your own mount.

2) keep engine, put on 1" bore heavy duty go kart clutch, not as fun, and may burn up clutch in the long run, but its a heavy duty one so you should be 'ok' as long as you don't try climbing hills and whatnot.

3) sell engine, and buy a TAV2, and predator 212cc engine, this is probably the most cost effective way to do it. You could probably get 2-250$ for that engine, you will lose out on power, but you will also not really have to spend any money (if you can sell the engine). This is also probably the most true to stock form you can get for that go kart.
Engine is here
and the 30 series TAV2 torque converter is here
 

Zombient

Junkyard Derelict
Messages
565
Reaction score
7
Location
Waco, Texas
:iagree: Basically what he said.

It's going to depend on 2 things.

Can you weld and/or how much money do you want to spend?
 

landuse

Moderator
Staff member
Messages
18,804
Reaction score
613
Location
Pietermaritzburg, South Africa

Zombient

Junkyard Derelict
Messages
565
Reaction score
7
Location
Waco, Texas
i just checked and i believe it has 13 teeth

Then that may be why it burned up in the first place. Your ratio could be way off. That will burn up a clutch quick.

Count how many teeth you have on the big sprocket (the one attached to the axle).
 

OzFab

Well-known member
Messages
15,615
Reaction score
76
Location
Warwick Qld, Australia
Didn't Yerf dogs come standard with a TC?

Ok, I know, they didn't have a 420cc engine so, perhaps, whomever fitted the bigger engine didn't have the dollars (or sense) to upgrade the original 30 series TC to a 40 series; my suggestion is fit a 40 series & all your issues go away...
 

colestreasures

New member
Messages
465
Reaction score
1
Location
Kentucky
I wouldn't run it any other way then with a T/C setup on it. Your not going to keep a centrifugal clutch on very long they just wont last , on what you have that is they are fine on other karts but you really need a Torque converter setup on that kart. When someone switched engines the done away with the original setup.
Cole
 
Status
Not open for further replies.
Top