Predator 301cc Amazon 40 series question

[Krinen]

Hello everyone,

I have been resurrecting an old Yerf Dog that was given to me for the kids. I am on the last leg of getting this running, I ordered a 40 series torque converter from Amazon to go with tmy 301cc. Problem is it did not come with the cone washer and with the width of the sprocket I need over an inch spacer on the crank for the clutch. I'm a bit uneasy about leaving that much of the clutch hanging off of the shaft, is that normal? I can try to get some pics tomorrow.

Here is the kit that I got.

Thanks in advance!!

 

[Texan]

I'm a bit uneasy about leaving that much of the clutch hanging off of the shaft, is that normal? I can try anal some pics tomorrow.

Here is the kit that I got.

Thanks in advance!!

Uh, good luck with the pics...

 

[frostyflammable]

I remember seeing these on the forum and I think the driver goes the other way around? The driver should have the "nut" facing towards the backplate, I think.

--Dan

 

[Krinen]

Here are the pics. Sorry for the delay

 

[Krinen]

I remember seeing these on the forum and I think the driver goes the other way around? The driver should have the "nut" facing towards the backplate, I think.

--Dan

If that is the case that makes sense as that would give me a ton of clearance.

---------- Post added at 08:17 AM ---------- Previous post was at 08:03 AM ----------

Uh, good luck with the pics...

LOL good call. **** iPhone.