Predator 212 carb gasket

Status
Not open for further replies.

Jrgunn5150

Rudderless
Messages
1,028
Reaction score
12
I'm installing a Predator 212 Hemi version into my Fox Vortex, and it will start and run with the choke on, but take the choke off or give it any gas and it dies immediately.

I believe I have, or HF has the gasket's screwed up, but with the thing off the motor, I can't see any obvious way it should go.

Does anyone have a good pic of what way the gaskets go? I have a paper one and a metal/oring one.
 

FreeRunner15

=======
Messages
660
Reaction score
10
Location
================
Problem:

engine barely works with choke completely on.
engine dieswhen fuel is added to the mix.

Solution(s) .... add more air into the mix OR restrict some fuel flow.
 

CoroTheCat

Builder
Messages
103
Reaction score
0
Location
Denmark
Now how on earth could you confuse the two?
That's like putting a square inside the circle hole.
Unless you meant the air box gasket and not the circle rubber washer under the stock air filter.

Everyone makes mistakes, i will be ready to make fun of you, when you make one freerunner :ack2:
 

Jrgunn5150

Rudderless
Messages
1,028
Reaction score
12
Now how on earth could you confuse the two?
That's like putting a square inside the circle hole.
Unless you meant the air box gasket and not the circle rubber washer under the stock air filter.

I mean the air box gasket, that is more or less identically shaped to the paper carb gasket.

When i pulled the carb to hook up my direct linkage, the gasket just fell off the studs. When i put them back on, I assumed the metal one would go nearer the head.

But that's why I posted back with what I had screwed up, in case someone else turns this up in a search someday. Because there are many pics on the web of the carb and gaskets, but not so many like the diagram Coro linked :cheers2:
 
Status
Not open for further replies.
Top