crispycritter47
New member
I have a Manco Hyper kart that I'm "rescuing" (for lack of a better term). I have replaced the Subaru Robin engine with a new Predator 212. And, I bought this TC from Amazon - "Bullet Lines ✮ Torque Converter Go Kart Clutch, Replaces Comet TAV2 3/4 inch 30-75, Manco, 10t 40 or 41 chain, small engine belt drive, 3/4" 218353A, (0.75" 10T 40/41)".
This is what I was told by the seller:
"The predator motor has a shoulder at the crankshaft that sits about 1/8 inch lower than other Honda or clone engines, and if you do not provide the right spacer, then the driver will rub on the back plate. Also, you will need the correct anti vibration pilot washer that is not included with this kit. You will need 5/16" -24 screws, 1/8" x 1 1/8" OD washer, and the correct balanced pilot washer."
I know I can get the screws and the 1/8" washer at the hardware store, but not sure about the "balanced pilot washer". Is it actually needed to make this TC work with the Predator?
Any help will be much appreciated!
This is what I was told by the seller:
"The predator motor has a shoulder at the crankshaft that sits about 1/8 inch lower than other Honda or clone engines, and if you do not provide the right spacer, then the driver will rub on the back plate. Also, you will need the correct anti vibration pilot washer that is not included with this kit. You will need 5/16" -24 screws, 1/8" x 1 1/8" OD washer, and the correct balanced pilot washer."
I know I can get the screws and the 1/8" washer at the hardware store, but not sure about the "balanced pilot washer". Is it actually needed to make this TC work with the Predator?
Any help will be much appreciated!