justinkk2005
New member
- Messages
- 56
- Reaction score
- 0
With a good milling (could'nt find a machine shop locally to do the milling) this would be an awesome head.
It's a bare head and will need rockers, valves, springs etc.
I port and polished it and thought I had ported it wrong as you can read on a thread on here but turns out it was a needle jet retainer in the carb! Head is good to go, only a few hours on the head.
$17 shipped
It's a bare head and will need rockers, valves, springs etc.
I port and polished it and thought I had ported it wrong as you can read on a thread on here but turns out it was a needle jet retainer in the carb! Head is good to go, only a few hours on the head.
$17 shipped