One last question

Status
Not open for further replies.

Brandon1023

needs an oil change
Messages
422
Reaction score
4
Location
Miami, Florida, Dade County 305
Sorry for double posting, I apologize. But I wasn't sure if this would get seen in the other thread. So anyway. I just took off the metal cover and flywheel of my Tecumseh 6.5 exposing the magnet since I need to replace a kill switch on the engine.

On the go kart frame, there is a killswitch with a green and black wire which connect to a plug where other wires plug in to it. Probly for head lights and what not. So from there, the black wire connects to the metal bracket on the gas tank. Meanwhile, the other green wire runs to the magnet. At the magnet, a green wire and a black wire both come out which connect to the additional killswitch located on the engine. I can't connect the kill switch from the gokart frame because the black wire is not long enough. Can someone point me in the right direction here? I'm getting no spark and I know it's from this. Thanks.
 

Attachments

  • go kart ignition.jpg
    go kart ignition.jpg
    31 KB · Views: 7
  • 2011-11-08_17.23.45.jpg
    2011-11-08_17.23.45.jpg
    22.2 KB · Views: 8
  • 2011-11-08_17.34.36 (1).jpg
    2011-11-08_17.34.36 (1).jpg
    17.8 KB · Views: 3

kendelrk

redneck engineer
Messages
2,425
Reaction score
9
Location
westland michigan
the broken switch is your kill switch, and i belive the one that goes from your gas tank, to plug, to circle kill switch, is for lights or somthing like that, have you tried to start it after taking out that kill switch? if your not getting spark from there, i suggest putting your kart again a wall or somthing and disconecting the wires from the other switch, then try to start, so basically, did it start after the other kill switch came off? if not unplug everything else and give it a try, if not it might be your coil,
 

Brandon1023

needs an oil change
Messages
422
Reaction score
4
Location
Miami, Florida, Dade County 305
The one that goes from the gas tank and plug will kill the engine as well. It's not going to start without that killswitch, I'm pretty sure since it's basically an open circuit. Right? I don't understand too much how the whole killswitch works.
 

Brandon1023

needs an oil change
Messages
422
Reaction score
4
Location
Miami, Florida, Dade County 305
Alright. I'll look. I just don't understand the whole ignition system. I'm trying to learn as much as I can about small engines so go easy on me. Is the green wire the ground? Because I know it usually is, but in this case, the black one is screwed on to the gas tank. Then theres the other black wire coming from the magnet.
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
It's not going to start without that killswitch, I'm pretty sure since it's basically an open circuit. Right?
Wrong. The kill circuit is normally open. When you activate the kill switch, it closes the circuit, grounding out the primary side of the ignition coil, disabling the ability to make spark. Remove the wire coming off the coil (green) and cover the open end, leaving the kill circuit completely open. If you still have no spark, problem is elsewhere.

FWIW, the wires are attached to the ignition coil- that's not a magnet. The magnet is installed in the flywheel.
 
Status
Not open for further replies.
Top