Noob Question (Drill Start)

Status
Not open for further replies.

thisismyusername

Donut Eater
Messages
250
Reaction score
3
Ok so i have the starter recoil off of my predator 212 to paint. I lost the 2 pins that go outward when the starter is pulled, so it wont work. So I figured i would just drill start it until my new recoil got in. But i was reading some thing online and it said that the bolt in the picture had to be torqued to a certain pound, and you would think that using a drill would tighten it all the way and go over the poundage. I feel stupid because im 99% sure you can drill start it using that bolt, so can you? Lol
 

Attachments

  • 20150905_231843.jpg
    20150905_231843.jpg
    193.5 KB · Views: 10

mckutzy

Well-known member
Messages
8,353
Reaction score
113
Location
bc, canada
Typically there is a "nut" that is threaded on there to accept an external starter, in a racing setting.
So your idea will work.
 

KartFab

Active member
Messages
3,381
Reaction score
60
Location
Dallas, TX
Be careful, but you can also start it with a piece of string wrapped around that little cup thingee (yes that's a word).
 

thisismyusername

Donut Eater
Messages
250
Reaction score
3
Be careful, but you can also start it with a piece of string wrapped around that little cup thingee (yes that's a word).

I tried wrapping a string around the cup thingy lol, it kinda slipped. Do you mean by be careful that it could brake or some thing?
 

rushking19

Active member
Messages
1,045
Reaction score
2
Location
Richmond Virginia
I tried wrapping a string around the cup thingy lol, it kinda slipped. Do you mean by be careful that it could brake or some thing?

No in certain cases some people's drills got stuck on while the motor fired up or the socket getting stuck and a socket spinning around 1000 rpm isn't safe so be careful
 
Status
Not open for further replies.
Top