Newbie question

Status
Not open for further replies.

speedracer

New member
Messages
3
Reaction score
0
Hey all,
just found this site a couple days ago, seems like a very good resource for kart info.
I bought a Vortex 169CC kart a couple days ago, used. In good shape but needs a belt. Having trouble matching one up. Read thru the sticky on TC maintenance, excellant info, but still need some help.
The belt currently on it is a Manco 5959 asymetrical. I was able to remove it without taking the TC apart, just slipped right off. Seems like maybe it is not the right belt.
It has a 5" drive, 6" driven, and 6.75" between centers of shafts. Does this sound correct? It has a Comet tc and on the driven it has a "20" on it, does that mean it is a series 20?
Can someone offer some insight on the correct belt?
 

r97

Measure twice cut once
Messages
3,793
Reaction score
9
Location
Massachusetts, USA
The 20 on the cam is no indication of the series numbers.

On both the driver and the driven, does the side of the pulley closest to the engine seem to be almost flat, while the other side is angled, or are both sides angled?

If one is flat, then you have a 30 series.

If you both are angled, you have a 20 series.

http://gokartsupply.com/identify.htm

Once you have determined the series number you can use this chart to see if you have the correct belt.
http://gokartsupply.com/tcbelts.htm

From my (limited) experience, the belt should not just slip off. If you have the right belt and you can still remove the belt, post a picture of the torque converter so we can try to help you resolve it.
 

speedracer

New member
Messages
3
Reaction score
0
Just rechecked measurements, drive is 5", driven is 6", 6.75 between centers, and it is an asymetrical.
Cant find anything that matches these measurements at the sites you suggested. The belt came on it, dont know if it is right or not, that is why I am here. Will try to post pics tomorrow, going to bed.
 

speedracer

New member
Messages
3
Reaction score
0
It has the Subaru engine, but know way of knowing it the tc has been changed. According to what I can find, the 203590 @ 28.32" is almost an inch longer than the 5959 @ 27.375". This would only make my problems worse, as is the 5959 slips right off the pulleys.
 
Status
Not open for further replies.
Top