Newbi looking to build pleas help

Status
Not open for further replies.

tsunamimike

New member
Messages
1
Reaction score
0
hey guys i had an off road go kart back when i was in elementary school with a 5hp briggs and straton motor well now i'm 23 years old and me and my buddies found great place to ride so i'm looking to build a custom one for me this time around,

I'm very good at fabrication and welding and have access to all kinds of equipment so the frame and everything is not what i'm worried about at all,

My question is about the engine / sprocket / torque converter set up, we are wanting carts that will be able to spin the tires on this hard packed gravel we will be riding on but we also dont want to loose much top speed ( this is where the torque converter would come in handy) but must i really buy a ridiculously large motor to break the back tires loose or could i get by with a 8hp motor? any input on sprocket sizes and motors would be great
 

OzFab

Well-known member
Messages
15,615
Reaction score
76
Location
Warwick Qld, Australia
The size of your motor is directly proportional to the size of the kart; there's no point telling you an 8hp will do fine if your kart ends up weighing 100 pounds.

To achieve what you want, I would suggest a motorbike engine; they have an integrated gearbox so you get your tyres spinning & also get a high top speed. Also, they usually have more power per cubic inch than an industrial motor. Again, the size depends on the size of the kart.

As for gearing, there are a lot of other factors to consider before tackling this area.

Give us a few more details about what you're planning (size wise) so we can give you a lot more advice
 

klicky96

New member
Messages
558
Reaction score
1
Location
Sandusky, Ohio
If you want a high speed and also high torque, you can use a bike engine with a gearbox, or you can use a Torque Converter. Torque Converters are good for small engines, like a Honda, Honda Clone, Briggs, Tecumseh, Etc. With a bike engine, you will not need one. You can still get a lot of power from a basic small engine, though. Keep this in mind while you are building:

The more weight your adding, the more power output you want.

You can build a 500lb kart, but you need the power to push it. Think about it this way. In my own words, I build by my number one rule; For every 100lbs, I run 2HP or at least I try to run that. As the weight goes up, I start to decrease a little.

With a torque converter, the engine itself will change the gearing from high to low. As you are taking off, it will throw the TC into a low gear, increasing torque. At high RPMS, it changes the gearing to a high gear. This decreases torque and increases speed. But, because the kart is not taking off from a still position, you will still have enough torque to increase speed.
 
Status
Not open for further replies.
Top