New to "Karting"

Status
Not open for further replies.

Weems

New member
Messages
5
Reaction score
0
I recently acquired a small, $50 Gokart. When I got it, it didn't run. After cleaning out the Carb and Gas tank, it started right up. It's a fun LITTLE kart. There are no markings on the engine at all, but I am fairly certain it is a 5hp Briggs and Stratton. The issue that I am having is that it has no low end power/torque. It takes a while for it to get up to speed. The governor has been taken off, but when you first start it up, it doesn't even rev up the way it should(in my mind... Very low RPM's).

I have attached pictures for reference, Thanks in Advance





 

Weems

New member
Messages
5
Reaction score
0
That what I was thinking, but wasn't sure. I am a complete noob however. What would be the best way to change that? I don't want to spend a lot of money on this, just want something for the nieces and nephews to mess around in when they visit, and for me to mess around in too... :)
 

Weems

New member
Messages
5
Reaction score
0
I think the back wheels are 18". If i got a 70+ tooth, would that help, or would it be barely noticeable?
 
Status
Not open for further replies.
Top