New to go karts GOT THIS FOR FREE!

Status
Not open for further replies.

bkelley17

New member
Messages
2
Reaction score
0
Hey everybody, I just picked up this go kart from a lady who just wanted it gone. It has been sitting for a while but I just got the tecumseh motor to run after cleaning the carb. My plan is to restore it, have a little fun with it, then sell it and make some money off of it.

As of right now the definite problems that I can tell are:

Needs new tires
Rust spots that I am in the process of sanding now
Prime/Paint
Engine needs a new pull start system (broke from me pulling it)
I took a look and the caliper looks pretty worn (cant seem how to take it off)

I am open to any recommendations on the entire project! I also would love to know what kind of go kart this is!

Thanks guys and gals in advance!
 

Attachments

  • go kart before.JPG
    go kart before.JPG
    105.9 KB · Views: 29
  • go kart before2.JPG
    go kart before2.JPG
    101.8 KB · Views: 27
  • 20150422_172225.jpg
    20150422_172225.jpg
    87.3 KB · Views: 17
  • 20150422_172209.jpg
    20150422_172209.jpg
    125.7 KB · Views: 15
  • 20150422_172154.jpg
    20150422_172154.jpg
    151.7 KB · Views: 21

KartFab

Active member
Messages
3,381
Reaction score
57
Location
Dallas, TX
new brake pucks (caliper should just unbolt into two pieces, or slides off with the disc)
new bearings
sand and paint
clean torque converter
put some slime in the tires and make sure they are not dry rotted.
new throttle cable

I like to use the rustoleum 'professional' spray paint (comes in silver cans with colored tops), comes in bright good looking colors and only need 1 coat of primer and 1 coat of paint. goes on real nice.
 

bkelley17

New member
Messages
2
Reaction score
0
okay thanks! do you think I am fine with keeping the tecumseh engine? And by chance do you know what kind of go kart this is or if it is a decent go kart?

I figured it was pretty nice since it came with the roll cage and all.
 

OzFab

Well-known member
Messages
15,615
Reaction score
70
Location
Warwick Qld, Australia
Welcome to the forum...

All good info from Grant (KartFab) :thumbsup:

I've never seen anything like it so, I can't help with the ID... it looks kinda cool though...

Depending on exactly what's wrong with the starter, it's most likely fixable... & will be easier to fix than replace...
 

2SlickNick

American Minibikes @ FB
Messages
2,758
Reaction score
30
Location
Mesa, AZ.
:welcome2:
That is an awesome kart and free non the less; whoa.
I have seen these for sale several times in my area. Plenty of info and help at DIY.
 
Status
Not open for further replies.
Top