new here but need some engine help

Status
Not open for further replies.

magicdragon

New member
Messages
9
Reaction score
0
i just made a go kart with the rear end of a rear engined lawnmower, just bolted right up


now here is the problem

its an old briggs 5 hp with points,

ive removed the governor and now ive got so much power im just loving it, my only concern is im afraid that im gonna ruin the engine, at this high rpm

i wanna keep the speed, but not kill my motor (though i do have a spare, but don't want to swap it out)

what can i do to upgrade the engine to run at this high rpm
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
you can get a billet connecting rod for a 5hp briggs and stratton flathead. find one on ebay or google it.

that would make sure the connecting rod will stay in tact...

however my usual rule is that if you remove the governor, the engine will be fine with stock internals. the valves will float around 5,500 and the engine will not keep building more speed.

but your engine is old and must be already very well worn (assuming) its over 30 years old, so keeping it wide open with the governor removed for a long time and little load can cause it to get too hot or throw the rod.

regardless, without upgrading many internals you should never keep it at 5,500 for a long time.

if the engine sounds like it has very little load on it, consider gearing it higher.

google search 5hp briggs raptor engines and their parts will fit in your engine.


welcome to the forums!
 

the-cyborg

New member
Messages
476
Reaction score
6
Location
Spring, Texas
Do a google search on raptor racing engine there are tons of mods and high performance parts for those old flat heads
and IMO were better, stronger engines than most of these new overhead valve engines these days.
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
and IMO were better, stronger engines than most of these new overhead valve engines these days.

:iagree: theres many old briggs still running today, and my newer 13.5 had to be torn down already.

they were some great engines.

early tecumsehs were awesome as well. ive got an h60 thats late 50's early 60's and a little TLC it ran. also have a almost brand new tecumseh with a blown rod. theres not even a spec of rust on the muffler yet.
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Another possibility here is regearing. If you were to raise the gear ratio, you could increase the load on the engine and decrease your chances of mechanical failure. It sounds like the rearend of the mower is intact so it probably has a fairly low overall reduction ratio. Does it have "lots" of power on a full-throttle start from a stop? If it does, you've got some wiggle room there. You would quite possibly see an increase in top speed, too.
 

magicdragon

New member
Messages
9
Reaction score
0
thanks for the advice on the raptor engines
and im planing on doing a pulley swap on the trans
 
Status
Not open for further replies.
Top