"new" comet 40 questions

[mr.matt]

So I just bought a new to me comet 40 drive and driven clutch, just the clutches. Is there any other hardware that I will need to get these installed? There were also 3 washers or spacers in the engine facing side of the drive clutch, what are these for? I have never used or installed either of these and wasn't able to find a lot on what all was needed so any helping me would be appreciated.

Also are there any markings to show authenticity on the driven? I see comet on the drive, but no markings on the driven, any ideas?

 

[Najuto9tail]

does your kart already have a torque converter?

Here is a complete kit

 

[landuse]

You will need to fabricate yourself a jackshaft. When you put the driven on the jackshaft, you must make sure that the center to center distances between the driver and driven correspond to whatever belt size you are going to buy

http://www.bmikarts.com/PDF/Comet_40series.pdf

 

[r_chez_08]

does your kart already have a torque converter?

Here is a complete kit

That's a tav2 style. Different..
You need a belt, a jack shaft, some bearings and a jack shaft sprocket.