Needing advice for an engine swap

Status
Not open for further replies.

oatz1000

New member
Messages
2
Reaction score
0
I have a MAXXAM 2r 150cc. We run it until it blew up with intentions of swapping the engine. I have an 8hp Kohler (from a mower), a 14hp Kohler (from a mower), a 12hp Honda (pressure washer) and a 20hp Honda (heavy-duty conveyor belt). We were leaning toward the 12hp Honda. I was just wondering if any of the other motors would be better? We also considered a 16hp log splitter motor from amazon priced around $200. We want it to be quick but nothing more than 45mph cause we will trail ride. Also, we want to keep it a two-seater, so it will have to be a motor strong enough to pull two grown people. Are there any motors that would be recommended online? We are noobs btw.
 

mckutzy

Well-known member
Messages
8,353
Reaction score
113
Location
bc, canada
Hello and welcome.

Id say what is the cheapest or the most affordable for the clutch or cvt. Off hand I think its going to be expensive none the less, as the shafts are 1" size and up.
 

oatz1000

New member
Messages
2
Reaction score
0
Hello and welcome.

Id say what is the cheapest or the most affordable for the clutch or cvt. Off hand I think its going to be expensive none the less, as the shafts are 1" size and up.



Money isn't an issue. I'm worried about the frame holding the power. I believe it can hold it's fair share cause it's pretty solid
Centrifugal clutches may be easy to find on amazon. But yes I believe the shaft on all of those are 1 in. Thanks
 

The Icebox

New member
Messages
11
Reaction score
0
I personally would go with the 12hp honda. I had a robin subaru 6.5 that needed a new carb and i decided this was my chance for more power (tim allen grunt inserted). I now have a 9hp honda with the room for plenty of extras later on for more power. A 12hp will have no problem in a two seater.
 
Status
Not open for further replies.
Top