Need help with clutch and sprocket

Status
Not open for further replies.

Fallenleopard

New member
Messages
194
Reaction score
2
Location
N.S.W Australia
I have a motorbike wheel and the project i am building i will be using a 41 or 35 pitch clutch but i need a rear sprocket to fit my motorbike wheel which is not really going to work does anyone have any advice?
 

landuse

Moderator
Staff member
Messages
18,804
Reaction score
613
Location
Pietermaritzburg, South Africa
I had the same problem with my minibike build. All my clutch and jackshaft sprockets were 35, and the pit bike frame sprocket was something else. I tried to get a plate sprocket that was 35 and had the tooth count that I wanted, but I couldn't. I eventually had to buy a sprocket that had a boss on it, and then had someone machine it off, cut the center hole larger, and drill the bolt holes for me.

This is a before and after
 

Attachments

  • sprocket.jpg
    sprocket.jpg
    16.5 KB · Views: 3
  • 25062011483.jpg
    25062011483.jpg
    115.6 KB · Views: 9
Status
Not open for further replies.
Top