hi!
im a new member on this forum
i have a baja warroir (mb165) and my bulb went out, after i installed my stage one kit (no governor, no problem). and i tried to do a led (re soldered the green wire) im not selling it, so value i could care less about. and it worked fine for about 2 minutes then the led burned out
so im wounder what should i do? h6m to h4 conversion?
any leds that can handle up to 24v (i measured my output from the coils, its 18v at 4500)
thanks!
im a new member on this forum
i have a baja warroir (mb165) and my bulb went out, after i installed my stage one kit (no governor, no problem). and i tried to do a led (re soldered the green wire) im not selling it, so value i could care less about. and it worked fine for about 2 minutes then the led burned out
so im wounder what should i do? h6m to h4 conversion?any leds that can handle up to 24v (i measured my output from the coils, its 18v at 4500)
thanks!
