my briggs flathead problem

Status
Not open for further replies.

vandancouver

New member
Messages
229
Reaction score
0
got a 5.5 briggs flattie, runs just fine (used to)

today i was in the dirt, the thing was running perfect all day..then all of a sudden when i floor it now it wants to cut out.

the thing idles great..just when i stomp on it, it wants to cut out...

i havent modded it out, just a straight pipe. i took the head off and there was some oil on top of the cylinder. i cleaned all that off, took off the carb and looked at the screen that goes into the gas tank..it was dirty, i cleaned that..i dont know what else it might be. its wierd..it idles just perfect. starts normal..just when i hit the gas hard it dies.

what could it possibly be
 

vandancouver

New member
Messages
229
Reaction score
0
no not yet. i only messed with it for a few minutes. i was kinda figuring it might be the diaphram on the side of the carb. the spring mighta rattled loose or something, or the washer came dislodged, im not sure. ill check that in the morning to see if thats it..hopefully it is. i got parts for that around here.
if its not that, what else could it be?
 

residentg

...why did I do that?
Messages
163
Reaction score
0
You might have dirt in the fuel tank. flush it out. When you put the carb back on, bend the long tube forward a bit. This is an old trick that is done to prevent the screen from hitting bottom and restricting fuel flow.
 

vandancouver

New member
Messages
229
Reaction score
0
im not sure if its hitting the bottom or not. cant tell. when i took the carb off and looked at the screen it was flithy. after you drain the gas out, whats the best way to actually flush it out. do they make a product or something
 

residentg

...why did I do that?
Messages
163
Reaction score
0
They do - but your best bet is kerosene. Otherwise you would use acid, but that should only be used for rust. Besides, there may be plastic baffles in the tank that may not react well to certain acids.

Clean the carb with carb cleaner and compressed air, and you should be ok.
 

vandancouver

New member
Messages
229
Reaction score
0
works now just fine. not sure what it was, i just deassembled the whole engine and put it back together *after cleaning it*

runs great now..heh
 
Status
Not open for further replies.
Top