Multiple Problems with Torque Converter

Status
Not open for further replies.

Thrahl

New member
Messages
7
Reaction score
0
I have a modified Manco Dingo that originally came with a 8 or 10hp engine and a Comet 40 series TC.
The engine was trash so it now has a 5.5hp Honda GX200 clone.
But the new engine has a 3/4 shaft rather than 1" so we went a got a 20 series drive clutch for it, but kept the 40 series driven.

It runs good for a bit but the belt gets stretched out within a few rides and is basically unusable after about 20 hours of use.
The engine is not adjustable relative to the jackshaft so I can't move it back to tighten the belt.
Belts are like $30-40 a pop so I can't afford to just keep putting new belts on.
The belt doesn't look worn at all and has no cracks or frays or anything, it's just stretched.

Is the problem because of my mismatched TC or something else? And what can I do to fix it? (short of buying an $80 20 series driven)
 

redsox985

Active member
Messages
4,092
Reaction score
12
Location
PA
The 20 series driver uses a 3/4" belt and the 40 a 7/8" belt. Make sure the belt is made for the specific center distance between the driver and driven also. Selling the 40 series TC will easily pay for a 20 series one, but I doubt you'll be happy with 5.5 HP when you used to have 10, in which case, you need the 40 again.
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Correct- Gx160=5.5hp, gx200=6.5hp.
And yes, you need to have matching driver and driven, and the correct pulley center distance.

If you're handy, resourceful, or lucky- you can buy/find/fabricate an adapter bushing to alow you to use the 40 driver on the new engine.
 

Thrahl

New member
Messages
7
Reaction score
0
Sorry it took so long to get back I have been busy.

@redsox985 - I have been running it with the 5.5 ever since I got it. The 10hp it came with was nonfunctional (don't know what was wrong with it, was before I cared about this stuff). So I don't know what I'm missing :p

@kendelrk - I thought so at first but I wasn't sure so I went on the Honda site and saw 4.8 http://engines.honda.com/models/model-detail/gx160. Maybe I am looking at the wrong stat.

@ toystory 4wd - when you say adapter, do you mean 3/4" to 1" adapter for the shaft? I have thought about that but I thought that since the 40 series says it is for 8-18hp it might pose a problem for my 5.5? (though I doubt it would be as bad as my current problem lol)
 

Thrahl

New member
Messages
7
Reaction score
0
@toystory 4wd - I did a lot of researching last night and figured out what I am going to have to do. Adapting a 40 series on to a 3/4" shaft seems like a somewhat common problem with a fairly easy fix.

Unfortunately yes I did throw the 10hp away. I built the go kart with my father years ago and at the time I didn't know anything about engines. Looking back I should have kept it and I could have possibly got it running again. Oh well though.

And yes I read that thread last night and it was very helpful.

I think I pretty much have all the info I need to give this a shot. Thanks for all of your help guys.
 
Status
Not open for further replies.
Top