motorized bmx

[Ghanem]

Hey guys iam trying to figure out what is the best way to mount a sprocket on a wheel and at the same time it is centered i tried many times but i couldn't get it at the center

here are some pics

http://i1215.photobucket.com/albums/cc502/ghanem999/IMG_5915.jpg

http://i1215.photobucket.com/albums/cc502/ghanem999/IMG_5918.jpg

http://i1215.photobucket.com/albums/cc502/ghanem999/IMG_5920.jpg

 

[B.M.800]

Can you find a washer to take up the extra room and weld it? maybe even if it fits inside the sprocket you could drill it out until it fits the wheel?

I duuno if that would be the best way though.

 

[Ghanem]

hmm i was thinking about doing that but iam trying to figure out a way so i can use the three holes

 

[B.M.800]

OOooooooooo...

Maybe you can find a bigger washer to weld to the wheel and bolt the sprocket to that?

 

[greengoblin]

nvm it wont work...

 

[Ghanem]

ya i just tac welded it and kept spinning the wheel till i got it centered and welded it really good, i also rode it i was going 60kph it was so fun

 

[voided]

I'd get a rim with flip flop hub and azonic used to make a disk brake for flip flop hubs. Use the disk brake base that's reverse threaded to the hub and match the disk to your sprocket and you will be all set..

Or you can use something like this
http://www.bicycledesigner.com/bike...sc-brake-adapter---free-or-flip-flip-hub.html