As explained in
your other thread, this engine is a chinese clone of the Honda GX200 &, therefore,
most GX200 clone parts
should fit/work...
As for freeing up the engine, it all depends on
how long the water was in there; more than a few weeks could mean the engine is toast...
Will the engine turn at all?
The best advice I can offer is remove the head & check the rust in the bore; if it's only light surface rust, you may be able to remove it successfully; if it's any heavier, it will need a rebore... if you can even
remove the piston...
Having said that, by the time you buy a replacement coil, strip down, bore the engine & buy all the necessary replacement parts to get it running, it would be cheaper to buy a new engine...
If it was a Honda I'd say go for it but, it's only a clone...