Motor and gearing question

Status
Not open for further replies.

aham2003

Member
Messages
219
Reaction score
1
Location
Cleveland, Tn
got a question for you gearing guru's. I have a briggs 8hp engine for one of my projects. the engine has a gear reducer on it. From everything I've read, it's either a 4:1 to 6:1 gear box. I was going to just take it off, but the crank has the gear made into iit and no keyway, so no chance of getting a clutch on it. my question it, what kind of speed would I get out of it? I can get a 10 12 or 14 tooth clutch and any sprocket that may be the best setup. I've attached pics of the motor and kart. Thanks guys.
 

Attachments

  • 20160511_194849.jpg
    20160511_194849.jpg
    271.7 KB · Views: 3
  • 20160511_194858.jpg
    20160511_194858.jpg
    220.5 KB · Views: 2
  • FB_IMG_1463010720661.jpg
    FB_IMG_1463010720661.jpg
    513.1 KB · Views: 3

Joe-405

Enjoying New Projects
Messages
2,673
Reaction score
98
Location
U.S.A.
I bet you could buy a regular side cover and just swap the whole thing out.
 

chancer

ɔ ɥ ɐ u ɔ ǝ ɹ
Messages
9,358
Reaction score
97
Location
COMFORT, TEXAS
Change the crank or find a different engine.
Even using that gear box if 4:1. A governed engine will turn 3600rpm.
so 4:1 reduction only gets you 900 rpms. A clutch wont even engage till 2000rpm.
 

aham2003

Member
Messages
219
Reaction score
1
Location
Cleveland, Tn
Came out smelling like roses. Selling the motor tomorrow for 150 and buying 2 methanol built briggs motors saturday for 200. Boom!!
 
Status
Not open for further replies.
Top