MaraschinoGirl
New member
- Messages
- 3
- Reaction score
- 0
Hi all
New to this, have some electrical experience but pretty limited.
I'm wheelchair bound most of the time and was recently given a mobility scooter that needed some work.
I've got it going (had to replace some wiring and put some new batteries and fuses in) but it's grossly underpowered.
I want to upgrade it a bit.
I'm not talking racing or high speed but basically, I figure if I'm gonna throw money at it, I'd like to get some decent power and range. I'd be happy with a top end around 40kms.
The plan is to turn the power down when it isn't needed and wind it up if the scooter is going to be offroad (like grass or uneven surface) and go up hill (I live in a hilly area) right now a curb cutout is almost too much for it.
I'm also future planning since Dad has bad knees and is a pretty hefty fella, I'd like to be able to offer it to him when needed that's not gonna burn out on him and still be able to motor along.
So I'm set on replacing the rear axle to basically a gokart one.
A motor
I figure I'm going to need a new controller - ideally bi-directional
I'd like to swap out the thumb control for hall effect twist controls
Brakes or a braking motor (or both)
And batteries
What I don't really know is sizing it all up.
A quick look at evilbay and I've found a 48v 1000w 26.7amp 3000rpm motor for around $100 but is that overkill?
Hope for some input.
Ta
Sarah
New to this, have some electrical experience but pretty limited.
I'm wheelchair bound most of the time and was recently given a mobility scooter that needed some work.
I've got it going (had to replace some wiring and put some new batteries and fuses in) but it's grossly underpowered.
I want to upgrade it a bit.
I'm not talking racing or high speed but basically, I figure if I'm gonna throw money at it, I'd like to get some decent power and range. I'd be happy with a top end around 40kms.
The plan is to turn the power down when it isn't needed and wind it up if the scooter is going to be offroad (like grass or uneven surface) and go up hill (I live in a hilly area) right now a curb cutout is almost too much for it.
I'm also future planning since Dad has bad knees and is a pretty hefty fella, I'd like to be able to offer it to him when needed that's not gonna burn out on him and still be able to motor along.
So I'm set on replacing the rear axle to basically a gokart one.
A motor
I figure I'm going to need a new controller - ideally bi-directional
I'd like to swap out the thumb control for hall effect twist controls
Brakes or a braking motor (or both)
And batteries
What I don't really know is sizing it all up.
A quick look at evilbay and I've found a 48v 1000w 26.7amp 3000rpm motor for around $100 but is that overkill?
Hope for some input.
Ta
Sarah
With a turret mounted .50 
That's a lot of woman to love.
