Mixing TAV DriveR Unit Garter Springs

Status
Not open for further replies.

bob58o

SuckSqueezeBangBlow
Messages
9,646
Reaction score
1,866
Location
Chicago-town USA
Any reason I shouldn't use two different garter springs in the TAV DriveR unit to get the engagement RPM I want?

The stock springs are BLUE (Comet 011187A) and engage at 3300 RPM with the Aluminum Die Cast weights (Comet 202931A).

If I use one BLUE Spring for 3300 RPM engagement and one WHITE Spring (Comet 011188A) for 4000 RPM engagement, will that give me around 3650 RPM? Will it cause any issues? Wacha Think???
 

Attachments

  • springs.jpg
    springs.jpg
    126.7 KB · Views: 0

itsid

Moderator
Staff member
Messages
11,563
Reaction score
261
Location
Ruhrpott [Germany]
not sure.. but since the weights cannot tilt really..
I don't see why one shouldn't try.

My guess would be, that on the long run, the white spring will weaken more than the blue one
(since it takes most of the abuse)

'sid
 

bob58o

SuckSqueezeBangBlow
Messages
9,646
Reaction score
1,866
Location
Chicago-town USA
I always forget the weight pack is also not symmetric and never take note of how it was. One side is flatter and the other side has more of an angle.

The outer shell (lubed) seems to have a more angled surface when compared to the inner shell’s flatter surface.

Makes sense that flat would go with flat and angled would go with angled, but I’m not 100%.

Last time I put one back together I had it backwards and had to switch it. Still don’t remember how it goes.
 

Attachments

  • attention.jpg
    attention.jpg
    16.5 KB · Views: 20
  • D4F1B789-6EC4-4F18-92EB-08F552A51F20.jpg
    D4F1B789-6EC4-4F18-92EB-08F552A51F20.jpg
    237.9 KB · Views: 1
Status
Not open for further replies.
Top