Mikuni vm22 jet kit

[bbrewer2005]

As the title suggests, I'm looking for a good jet kit for a mikuni vm22 (I have a Chinese clone from go power sports). I have seen a few but I'm a bit skeptical of buying one and it not being the right jets, there's so many variants.

Also, does anyone know what the factory jetting is off the top of their head?
Thanks!

 

[2SlickNick]

Here is what I have used...
https://www.ebay.com/itm/Wingsmoto-...335546?hash=item1ccaabb77a:g:RhYAAOSw81lccCRg

 

[bbrewer2005]

Here is what I have used...
https://www.ebay.com/itm/Wingsmoto-...335546?hash=item1ccaabb77a:g:RhYAAOSw81lccCRg

Sweet, thank you!
Do you by chance know what was factory, and what you finally settled with? Also, what is your setup, and did you get the carb from go power sports? They claim to have rejetted them in their shop from whatever factory from mikuni is. I have yet to put mine on for this reason.

All my buddy's have matching stage 1 212s with mikunis and theirs is extremely lean with factory jets from gps.

 

[2SlickNick]

I think factory was87 or 91 main jet. I buy mine from ebay and just tune it from there.

 

[bbrewer2005]

Any idea on where I should start with a stage 1 212? I really don't want to pay more for jets than I did the whole carb kit.

 

[2SlickNick]

There is too many variables... I had two of the exact same modified builds but one required a 125 main jet and the other 115 main jet. Casting on all these heads varies. Plus they are not true mikuni carbs so that plays a part too. I hear of many people get lucky and just can plug and play with just adjusting needle height.