Maxtorque on Briggs intek

Status
Not open for further replies.

beast02

New member
Messages
5
Reaction score
0
I have a maxtorque clutch i am trying to install in a briggs intek 206 , issue is the shaft is too short for a nut, and there is no keyway, how do i solve this?
 

Attachments

  • image.jpg
    image.jpg
    246 KB · Views: 17

landuse

Moderator
Staff member
Messages
18,804
Reaction score
613
Location
Pietermaritzburg, South Africa
Ok, so how do you fix this?

You need a keyway. You will have to take it to a machinist and get one machined into your crank

Or....you can look on ebay for a new crank with a keyway

Take a pic or two of the output shaft without the clutch on for us to see. Maybe there is something we are missing
 

beast02

New member
Messages
5
Reaction score
0
Well, sounds like I have an engine I can't use! There is no keyway, the end is not drilled/tapped, all there is are the threads on the end of the shaft which isn't even long enough to get a nut on the end.

Looks like i'll be selling this and getting a HF 6.5hp!
 

chancer

ɔ ɥ ɐ u ɔ ǝ ɹ
Messages
9,358
Reaction score
97
Location
COMFORT, TEXAS
Can you weld? A little off topic but you can use that muffler and pipe on the predator if you just weld it to the stock predator flange after cutting off the stock box muffler.
Just trying to find a bright side for you. LOL
 

rushking19

Active member
Messages
1,045
Reaction score
2
Location
Richmond Virginia
I have a similar engine Briggs and Stratton intek 850 series, and it runs good and sounds good with the header and rlv muffler I put on it
 
Status
Not open for further replies.
Top