a1parrothead
New member
- Messages
- 4
- Reaction score
- 0
Hello all,
Just bought an 8hp manco dingo and am fixing it up. My question is about the front shaft that part of the torque converter mounts to. On the OPPOSITE side of the engine from the belt and sprocket, you can see that shaft at the front of the engine where it passes through a bearing (Mine had a red plastic cap covering it), my question is: Does this look right? Its just a nut up against the bearing, and does not seem correct to me.
If someone could help, or even post a picture of theirs, it would help!
Just bought an 8hp manco dingo and am fixing it up. My question is about the front shaft that part of the torque converter mounts to. On the OPPOSITE side of the engine from the belt and sprocket, you can see that shaft at the front of the engine where it passes through a bearing (Mine had a red plastic cap covering it), my question is: Does this look right? Its just a nut up against the bearing, and does not seem correct to me.
If someone could help, or even post a picture of theirs, it would help!