Looking for 3/4 jackshaft

[dcook3333]

Hello!
I'm looking for a 3/4 inch jackshaft which has at least one end drilled and tapped. Any length over 8 inches would do. I know that I can do that myself, but how I plan to use that demands a pretty exact center hole. Everything I see out there is not threaded. I guess that I could have someone do it, but off the shelf would be quicker and probably cheaper. Any ideas?

 

[anderkart]

This site: http://www.bmikarts.com/shop/?shop=1&cat=272 shows a complete jackshaft with mounting plate described as "Clutch Mount with Jackshaft" that apears to have a threaded hole, but you might try contacting them before ordering to make sure.

I think the high quality shafts you'll find here: https://ssl11.chi.us.securedata.net/test.burrisracing.com/merchantmanager/index.php?cPath=103 have 1 or 2 threaded ends too. (again contact them first to make sure)

 

[kart mania]

or http://www.northerntool.com/shop/tools/product_23633_23633

 

[devino246]

or http://www.northerntool.com/shop/tools/product_23633_23633

Seriously??????

Pay attention to the date in the upper left corner of the previous post. The date is 01-25-2010, almost 9 months ago!

Does anyone know if VBulletin have an option to lock all threads over a month old, other than for the OP?

 

[fowler]

u should be able to set the expirery of your own thread

 

[devino246]

u should be able to set the expirery of your own thread

 

[redsox985]

Kart mania. Stop bumping threads If I ever get admin power, so help me God, I will ____________________. (fill in the blank with your choice of actions)

 

[Doc Sprocket]

Kart mania. Stop bumping threads If I ever get admin power, so help me God, I will ____________________. (fill in the blank with your choice of actions)

I second the motion. Seriously. The guy's made a total of 7 posts, and ALL SEVEN were dead threads and made no particular contribution...