Dakota8800
New member
- Messages
- 2
- Reaction score
- 0
Hello, I am new to forums and apologize in advance for any mistakes I may have made in this thread.
Now to the question, I have a Manco Eagle Phoenix II with a knockoff 30 series torque converter installed on my Predator 212. (Jet, intake and header installed) My Predator seems to idle high and shoots off as soon as the choke is turned off. Adjusting the idle screw did not help. I made sure I installed the TC correctly, yet after maybe 15-20 minutes of riding the bolt holding the driver clutch (5/16-24 X 2") Keeps coming out causing it to explode in a flurry of clutch parts. The belt is in good shape and installed with the flat end toward the engine. The bolt seems to be VERY snug when tightening and only contacts the clutch cover when washers are installed. I have bought a new 30 series driver and the same thing happened. Help is much appreciated.
Thanks for reading.
Now to the question, I have a Manco Eagle Phoenix II with a knockoff 30 series torque converter installed on my Predator 212. (Jet, intake and header installed) My Predator seems to idle high and shoots off as soon as the choke is turned off. Adjusting the idle screw did not help. I made sure I installed the TC correctly, yet after maybe 15-20 minutes of riding the bolt holding the driver clutch (5/16-24 X 2") Keeps coming out causing it to explode in a flurry of clutch parts. The belt is in good shape and installed with the flat end toward the engine. The bolt seems to be VERY snug when tightening and only contacts the clutch cover when washers are installed. I have bought a new 30 series driver and the same thing happened. Help is much appreciated.
Thanks for reading.
