kick start and Briggs???

Status
Not open for further replies.

r97

Measure twice cut once
Messages
3,793
Reaction score
9
Location
Massachusetts, USA
It is possible, but not very easy or inexpensive. Search the forum a bit and you should dig up some kick starter threads to give you an idea of what is involved.
 

B.M.800

TheBeal.
Messages
2,387
Reaction score
26
Location
Central PA
^^ I slightly dissagree...
Heres an easy cheap method.


Now, I think that uses an older pull start clutch thingy... I think now they have a some sort of band spring in em? Do the older pull start clutch thingys have the same bolt lineup?
 

r97

Measure twice cut once
Messages
3,793
Reaction score
9
Location
Massachusetts, USA
^^ I slightly dissagree...
Heres an easy cheap method.


Now, I think that uses an older pull start clutch thingy... I think now they have a some sort of band spring in em? Do the older pull start clutch thingys have the same bolt lineup?

Only problem there is that you get less than half of a revolution per kick, maybe it works fine and dandy, I couldn't tell you for sure. The way I see it you would be kicking that little lever many times to get it started, especially if the engine is cold.

Yes it is relatively easy to make, but I would rather put in more effort while making it and use less effort to operate it.
 

B.M.800

TheBeal.
Messages
2,387
Reaction score
26
Location
Central PA
Only problem there is that you get less than half of a revolution per kick, maybe it works fine and dandy, I couldn't tell you for sure. The way I see it you would be kicking that little lever many times to get it started, especially if the engine is cold.

Yes it is relatively easy to make, but I would rather put in more effort while making it and use less effort to operate it.

Like I said, "slightly disagree".
:D

Id be willing to try it though...
Maybe a slight variation though, with 2 gears that mesh togeather... kinda like whats on the little briggs kick start engine I got..

Though, if its anything like the honda I got, it start soooo easy makes me wonder if something is wrong haha...
:roflol:
 

mckutzy

Well-known member
Messages
8,353
Reaction score
113
Location
bc, canada
On a Honda clone I dont think you will have enough throw to make a good spark. With their type of ignition, I Believe It needs a few rotations to get the hot spark going or at least the speed in which the energy is produced.
I tried to rig up a ratchet with a socket for the flywheel nut without the fan cover on. I could not get enough spark by kicking. Just couldnt get enough throw.

Rigging up the cord to a lever and see if that is enough. I saw it somewhere on u tube or somewhere, that seems to work in theory.
 

r97

Measure twice cut once
Messages
3,793
Reaction score
9
Location
Massachusetts, USA
Maybe a slight variation though, with 2 gears that mesh togeather... kinda like whats on the little briggs kick start engine I got..

Yeah, a ratio of some sort will be needed, a homemade kick start for my mini bike is on the to-do list. I'm planning to use a one way needle bearing as the clutch, and some #25 chain n' sprockets to provide a 1:4 ratio between the kicker and crankshaft. Hopefully everything should be contained in a cast aluminum case that bolts to the side of the engine. Surplus center is now selling some spur gears that could work very well for something like this.
 
Status
Not open for further replies.
Top