Kart Rebuild

Status
Not open for further replies.

duane1969

New member
Messages
10
Reaction score
0
Location
Ronceverte, WV
This will be the first project attempt for my son and I. He is 11 by the way.

We are starting with a kart that I bought in a package deal from a pawn shop down the road from us. One of the karts is a retail model of unknown manufacture with a B&S 3.5hp engine. It runs but needs minor engine work (oil leak) and a carb rebuild (won't idle). Other than the oil leak fix and carb clean-up/rebuild this one will receive no more attention and will strictly be a buzz around kart for him and his friends to ride around the property.



The second kart (below) is our project kart. Again a frame of unknown manufacture, but it is very sturdy and solidly built. I think it may be a kit, but I am not sure. The engine is a DOA B&S 5hp. Rather than try to resurrect the engine I elected to find a solid replacement and bought a Tecumseh HS50 5hp that is already set up for an electric start and kill switch off of eBay for just under $125 delivered. It just arrived yesterday via UPS.



This is the "new" engine. Unpacked it yesterday evening and it looks good with the exception that the muffler is rusty. So that will be replaced. Only other issue I foresee is the gas tank location. As it sits now it will dig into the drivers right shoulder once the engine is installed.



Items on the to-do list:

Remove old engine - finished 1/29
Strip down frame and clean off any rust then repaint -
Replace throttle/brake pedal system with new cables, pedals and all-
Replace inner tubes on front tires -
Install inner tubes on rear tires -
Resolve padding issue on seat -
New bushings/bearings -
New muffler on engine -
 

landuse

Moderator
Staff member
Messages
18,803
Reaction score
611
Location
Pietermaritzburg, South Africa
I look forward to your progress on this. Relocating the gas tank should not be too hard. As long as you mount it at the same height (or higher) than what it is now, you will be fine
 

Beach Bum

Member
Messages
39
Reaction score
5
Location
Texas
I like both of them. To me, the second one has a RUPP Dart or D-300 look to it with some "slight" modifications.

Best of luck with the rebuild.
 
Status
Not open for further replies.
Top