kart nearly done

Status
Not open for further replies.

r1ng3l78

New member
Messages
7
Reaction score
0
i had posted back in december about a kart i was building for school that was to be able to pull a trailer around a farm with about 200lbs of cargo in it. there was quite a bit of contention as to whether or not the tc2 converter i paired with a 13hp clone would hold up to 400lbs of driver and cargo plus the weight of the kart. well, i chanced it and did some test runs today and they went well. the first two runs were with me working the throttle and my buddy steering (no controls yet) which totaled 480lbs plus the kart. for the hill testing, we never loaded it with more than 380lbs since the frame isn't finished. also we never exceeded half throttle during the tests.

i can't speak for the longevity of the belt yet, but for the hour we ran it, it's showing no signs of wear other than the excess fibers in the belt beginning to wear off.

and now for some video fun;
http://www.youtube.com/watch?v=pLg6HY23Smw
http://www.youtube.com/watch?v=o7k8wfGPMkQ
http://www.youtube.com/watch?v=Wj4IbvtUBOs
http://www.youtube.com/watch?v=O3vVe8BmZ5I

if you watched those, yes, the single A arms are going bye bye since just aren't working great with that much weight on them.
 

r1ng3l78

New member
Messages
7
Reaction score
0
problem is i don't want the camber to go very positive since this is a yard kart because that could make for a bad landing if the front end unloaded. also it wasn't designed to haul 500lbs of sprung weight. with 200lbs on it, it's not so bad but still needs an adjustment. i'm doing this for school and the current setup is adequate for class purposes and once i get my credit, this things getting uneven A arms, a better steering setup, and probably some sort of atv engine. i'm also toying around with cantilevered shocks. but for the time being, i'll be pleased with the converter holding up.
 

r1ng3l78

New member
Messages
7
Reaction score
0
well, i've tweaked the front suspension (since i was doing something stupid and broke it) and got the camber where i like it. clocked it at 32mph which is what it was supposed to top out at and now it's time to tear it down and do the final weld and assembly.

http://www.youtube.com/watch?v=ToANZgL5eVE
 

KasalmoR

New member
Messages
15
Reaction score
0
That looks pretty nice!:thumbsup: Can you post some close detail pictures of it? I would also want to ask how much degrees camber you made it? I am trying to figure out right camber angle for single A-arm setup and I will be glad if you could share some info.
 

r1ng3l78

New member
Messages
7
Reaction score
0
right now it sits at 2 degrees positive with no load and with a 200lbs rider on it it's at 6 degrees negative. that's about halfway thru the travel of the shocks. the steering is a little tight on pavement but it's much better on dirt. the trick i've found with single A arms is they want to jack in hard corners and i didn't want too much positive camber on the outside tire when i need it biting. i'll get more pics up once i've finished the final assembly and paint. don't want anyone making fun of my rusty kart. ;)
 

r1ng3l78

New member
Messages
7
Reaction score
0
forgot i had uploaded some pics already and some things have been changed since these were taken. and they're huge so sorry if your dial up.









 
Status
Not open for further replies.
Top