Kart for the Kids

Status
Not open for further replies.

jsb99

New member
Messages
3
Reaction score
0
Location
Texas
Just bought a Yerf Dog 3203, it has a Tecumseh 6.5 engine that is shot. I have searched the forums for a couple of days and it looks like I will be buying the HF 212cc Predator engine.

Based on the posts I have read this looks to be a direct bolt in swap.

Is there anything I am missing? throttle hook up, longer bolt/ shims.

This is our first kart, so my knowledge is limited.

I'm learning and the kid's are wanting to ride, ride, ride, so any assistance is greatly appreciated.

I will post pics when I get started.

Thanks,

JSB :confused:
 

klicky96

New member
Messages
558
Reaction score
1
Location
Sandusky, Ohio
This should be a disconnect and reconnect setup. the HF 212cc i believe comes with the throttle setup, meaning all you have to is reconnect the throttle once you bolt it down and put the chain on.
 

jsb99

New member
Messages
3
Reaction score
0
Location
Texas
We may have a problem

Here we go...

Old motor out and new motor installed but when I was putting it all back together again I ran into this; the Predator 212 cc engine has a 3/4″ x 2.41″ shaft my old Tecumseh 6.5 power sport is 3/4" x ~2.8" shaft. So my bolt wont reach the threads on the pulley.

My question is what should I do?

This is a Yerf Dog 2303 with torque converter.

Is it OK to use a longer bolt to make up the difference or any suggestions are greatly appreciated.:cheers2:

Thanks,

JSB
 

jsb99

New member
Messages
3
Reaction score
0
Location
Texas
Jake, thanks for the help...there is approx 50% of the clutch on the shaft.

Not sure what my next step is?

Different engine or a fix. I will try to post pics tomorrow.

Thanks,

JSB
 

landuse

Moderator
Staff member
Messages
18,804
Reaction score
613
Location
Pietermaritzburg, South Africa
You can generally just use a longer bolt to attach the driven. Wait for someone a little more experienced than me though.

Or you can PM Blazkowiez and ask him. He works at a kart shop
 

Jump

New member
Messages
5
Reaction score
0
Yes - longer bolt is fine, evertbody does that on the honda freight engines. Just use a strong bolt - Grade 8 bolt if your hardware store has it. I also put a few drops of removable loctite threadocker on it, but not sure if that's really needed; I just felt safer using it. It's been running like that a couple years with no issues.
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
I assume you have a 30 series?
These have the back plate and the splined hub. On mine the splined hub only goes on the shaft 1/4". It's fine!
 
Status
Not open for further replies.
Top