just an idea

Status
Not open for further replies.

kendelrk

redneck engineer
Messages
2,425
Reaction score
9
Location
westland michigan
i just had an idea, i was thinking of taking, 2 maybe 5 in by 3 in boards, putting caster wheels on one, and lawn mower wheels on the back, attaching a sprocket to the wheel, trash picking an engine, and fixing it for the back, all heald together by a long but wide board, then get some I lits and put a rope through them for steering, get a go kart seat, and hook up the engine, the throttle can be like a lever like _\ and you can pull back to _/ for throttle, and then having some milk gallon gas tanks, go idea? :cheers2:
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Bad idea. Unless you wish to die in a blaze of flaming toothpicks. We generally tend to discourage such things around here. Not a good idea at all.

Wood is for soap box derby (unpowered) karts.
 

kendelrk

redneck engineer
Messages
2,425
Reaction score
9
Location
westland michigan
well even though itd be a pretty cool way to die, im trying to make a very low budget one for my 10 year old brother, could i do the same thing with steel instead of wood?
 

CriticalMass

New member
Messages
239
Reaction score
1
Location
East Bay CA
There is no cool way to die, there's stupid, there's tragic, and there's pitiful ways, never a cool one. Unless you died under a mountain of naked babes, I don't think that's happened yet.
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
and use bolts to hold it together? it would have to be engineered pretty well. i wouldnt go more than 15mph on a bolted together kart.

what about getting an old, old, crappy frame off craigslist, wash it down, do some refurbishing, and spray paint it?

youd be amazed what you can find. my friend just got a 6.5hp dingo (i think it is) with a torque converter for $150.

my kart that was super crappy but needed a clutch and chain, was $50. i decided to do a major modification and refurb of the entire thing. i have about $170 into it total including a new engine, bearings, steel, disks, wire, new tires, axles, etc.
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
If you're doing a bolt together, limit speed to about 10MPH or less, and a low displacement. Make sure the dang thing is dead solid, and frequently check all fasteners for tightness.
 
Status
Not open for further replies.
Top