Junk yard build

Status
Not open for further replies.

Charliekelly77

New member
Messages
5
Reaction score
0
So I'm trying to build a mini bike from some junk I have in my garage. I got the bike and this what I believe is a Tecumseh engine from the 80's. I've got the design kinda down. I'm a little concerned about the flywheel since it used the blade for momentum. I'm not trying to buy a lot of parts but I am buying a centrifugal clutch. Will that be enough weight or am I going to have a problem in between strokes. I'm a novice so if you have any heads up info for me, I'd much appreciate it.
 

Ebrownie

Member
Messages
582
Reaction score
8
Location
Western Montana
Welcome to the forum! Unfortunately, I can not help you very much without pics of what you have. Get some pictures up and we should be able to give better advice :thumbsup:
 

Charliekelly77

New member
Messages
5
Reaction score
0
I'll try and get some pics up. But I know it's an aluminum flywheel. My question is Will the clutch and resistance be enough to balance or will it just back fire and stall.
 

Charliekelly77

New member
Messages
5
Reaction score
0
Pics
 

Attachments

  • 20170708_215903.jpg
    20170708_215903.jpg
    395.2 KB · Views: 4
  • 20170708_215855.jpg
    20170708_215855.jpg
    329 KB · Views: 4
  • 20170708_215846.jpg
    20170708_215846.jpg
    400.4 KB · Views: 3

karl

Well-known member
Messages
2,449
Reaction score
719
Location
North east Ohio
That is not good minibike motor. Shaft size, mounting, carb issues, oiling issues, no good.get a proper horizontal shaft
 

Charliekelly77

New member
Messages
5
Reaction score
0
Hahaha. I know I'm saving up for a proper build. But I did already make a mounting plate, a plate to turn the carb, and I added a l bracket to the bottom of the crank (the governor looks like it should sling some oil too. ) Do you think I need anything else to get going. What's the problem with the shaft
 
Status
Not open for further replies.
Top