John deer L110

Status
Not open for further replies.

fowler

New member
Messages
5,463
Reaction score
18
Location
Bullsbrook West Aus
We've picked up a john deer L110 ride on mower

It has an 18 hp koler

It is good at cutting anything u run over and is used to mow our horse paddock

Recently the hydrostatic drive has given up the ghost

If u try to move u can here the pump spinning but u get no action
If u push it u get limited movement
It sounds like it is low on oil but I cant find any fill or drain points

All the linkages work (on the out side anyhow)

Don't have a great understanding of these enclosed judo drives

On a different note
We got a victa push mower to replace our old Briggs
The rust rigged though the briggs in short time
But the victa has far better build quality even though they are owned by Briggs
 

Nodroz

New member
Messages
1,071
Reaction score
10
Location
Belgium (Europe)
I have the same type of engine, but the one with 8hp.

I can't believe there aren't any drain or fill holes for the oil. The fill hole is on mine just next to the exhaust.
 

slideways

New member
Messages
575
Reaction score
6
Make sure the belt is tight and not just slipping on the pulley. Alot of times people think their trans is bad but really the belt can't grip the pulley anymore and slips alot. I've also had people think their trans was bad just to find the little woodruff/half moon keyway missing on the input shaft. .69 cents and you're mowing again.
 
Status
Not open for further replies.
Top